Basaltic Lapilli used for construction purposes in the Canary Island, Spain

Environmental and Engineering Geoscience. Volume 12, Issue 4, November 2006, Pages 327-336 DOI: 10.2113/gseegeosci.12.4.327 BASALTIC LAPILLI USED FOR CONSTRUCTION PURPOSES IN THE CANARY ISLANDS, SPAIN Lomoschitz, A.a, Jiménez, J.R.a, Yepes, J.a, Pérez-Luzardo, J.M.b, Macías-Machín, A.c, Socorro, M.d, Hernández, L.E.e, Rodríguez, J.A.f, Olalla, C.g a Department of Civil Engineering, Universidad de Las Palmas de Gran Canaria, 35017 - Las Palmas de GC, Spain b School of Architecture, Universidad de Las Palmas de Gran Canaria, 35017 - Las Palmas de GC, Spain c Department of Chemical Engineering, Universidad de Las Palmas de Gran Canaria, 35017 - Las Palmas de GC, Spain d Department of Mechanical Engineering, Universidad de Las Palmas de Gran Canaria, 35017 - Las Palmas de GC, Spain e Área de Laboratorios y Calidad de la Construcción, Viceconsejería de Infraestructura y Planificación, Gobierno de Canarias, C/ Talavera s/n, Llano del Moro, 38291 Santa Cruz de Tenerife, Spain f Department of Edaphology and Geology, University of la Laguna, 38206 La Laguna, Spain g Laboratory of Geotechnics, Centro de Estudios y Experimentación de Obras Públicas (CEDEX), C/Alfonso XII, 3, 28014 Madrid, Spain Abstract Basaltic lapilli have been extensively used in the Canary Islands in the construction industry and their abundance encourages an understanding of their properties as aggregate. They are small pyroclastic fragments, dark colored, with 8.5 to 33 percent of interconnected voids. This high porosity is the cause of low unit weights; dry unit weight ranges between 8 and 12 kN/m3 (50.95-76.43 lb/ft3) and moist unit weight usually varies between 11 and 16 kN/m3 (70.06-101.91 lb/ft3). From a geotechnical perspective, lapilli are essentially coarse granular material with friction angles of 34-37°, cohesion of 137-176 kN/m2 (2.86-3.68 lb/ft 2), and unconfined compressive strength, qu, equaling 0.39-0.54 MN/m2 (8.15-11.28 lb/ft2). They are used as coarse aggregate in mass concrete and the compressive strength reaches 25.97 MPa at 28 days, with a characteristic strength of fck = 25 MPa (3,625 lb/in.2). The lack of reactive silica eliminates alkali-silica reactivity problems with Portland cement. Concrete blocks with lapilli are normally used in the Canary Islands. The 250d type provides the best characteristics and even serves for structural bearing walls. It reaches a high block strength index (Bk ≥ 6 N/mm2), and provides effective sound and thermal insulation. This material can also be used as a granular material for highways, although the results from compaction tests (Proctor and CBR) vary widely. This extensive Canarian experience with basaltic lapilli could serve as a useful guide for other volcanic areas of the world.